PONCHICKERS™
How to apply
by PONCHI StickMagic™ · Snap it. Stick it. Stays for real.
Printed with UV-cured ink on transfer film — UV DTF, the technology commercial signage is made with. Waterproof, scratch-resistant, and raised slightly so you can feel the design under your thumb. Bonded to the surface rather than sitting on it, which is why the steps below matter.
Can't play the video? Every step is written out below.
-
Clean
Make sure the surface is clean, dry, and free of dust or oil.
-
Peel the backing
Carefully peel the sticker away from its paper backing. The design stays on the clear film.
-
Apply
Place it on the surface and press firmly, working from the centre outward so no bubbles get trapped.
-
Press & lift
Press once more all over, then slowly peel away the clear transfer film. Go slowly — if any part of the design lifts with the film, lay it back down and press again.
Before you start
- Use on smooth, nonporous surfaces only.
- The surface must be clean, dry, and free of dust or oil.
- Not recommended for rough, porous, or fabric surfaces.
- Allow 24 hours to set before heavy use or washing.
- Hand-wash only — never put it in the dishwasher.
Not dishwasher safe
Hand-wash only, around the sticker — warm water and a soft cloth. Dishwasher heat, jets and detergent will lift the edges and fade the print. Avoid soaking, scrubbing, bleach and abrasive sponges. Not for microwave use.